Oil field operations likely triggered earthquakes in California a few miles from the San Andreas Fault
- Written by Thomas H. Goebel, Assistant Professor, University of Memphis
The way companies drill for oil and gas and dispose of wastewater can trigger earthquakes, at times in unexpected places.
In West Texas, earthquake rates are now 30 times higher[1] than they were in 2013. Studies have also linked earthquakes to oil field operations in Oklahoma[2], Kansas[3], Colorado[4] and Ohio[5].
California was thought to be an exception, a place where oil field operations and tectonic faults apparently coexisted without much problem. Now, new research shows that the state’s natural earthquake activity may be hiding industry-induced quakes.
As a seismologist[6], I have been investigating induced earthquakes in the U.S., Europe and Australia. Our latest study[7], released on Nov. 11, shows how California oil field operations are putting stress on tectonic faults in an area just a few miles from the San Andreas Fault.
Seismic surge
Industry-induced earthquakes have been an increasing concern in the central and eastern United States for more than a decade.
Most of these earthquakes are too small to be felt, but not all of them. In 2016, a magnitude 5.8 earthquake damaged buildings in Pawnee, Oklahoma, and led state and federal regulators to shut down 32 wastewater disposal wells[8] near a newly discovered fault. Large earthquakes are rare far from tectonic plate boundaries, and Oklahoma experiencing three magnitude 5 or greater earthquakes in one year, as happened in 2016, was unheard of.
Oklahoma’s earthquake frequency fell with lower oil prices and regulators’ decision to require companies to decrease their well injection volume[9], but there are still more earthquakes there today than in 2010.
A familiar pattern has been emerging in West Texas in the past few years: drastically increasing earthquake rates well beyond the natural rate. A magnitude 5 earthquake[10] shook West Texas in March.
How it works
At the root of the induced earthquake problem are two different types of fluid injection operations: hydraulic fracturing and wastewater disposal.
Hydraulic fracturing involves injecting water, sand and chemicals at very high pressures to create flow pathways for hydrocarbons trapped in tight rock formations. Wastewater disposal involves injecting fluids into deep geological formations. Although wastewater is pumped at low pressures, this type of operation can disturb natural pressures and stresses over large areas, several miles from injection wells.
References
- ^ 30 times higher (doi.org)
- ^ Oklahoma (doi.org)
- ^ Kansas (doi.org)
- ^ Colorado (doi.org)
- ^ Ohio (doi.org)
- ^ a seismologist (www.ceri.memphis.edu)
- ^ latest study (doi.org)
- ^ shut down 32 wastewater disposal wells (apnews.com)
- ^ decrease their well injection volume (doi.org)
- ^ magnitude 5 earthquake (earthquake.usgs.gov)
- ^ U.S. Geological Survey (www.usgs.gov)
- ^ cause faults to slip and trigger earthquakes (science.sciencemag.org)
- ^ instruments (maps.conservation.ca.gov)
- ^ that detect even tiny events (maps.conservation.ca.gov)
- ^ largely free (pubs.geoscienceworld.org)
- ^ detailed seismologic study (doi.org)
- ^ CC BY-ND (creativecommons.org)
- ^ deeper geologic basement (doi.org)
- ^ Sign up for The Conversation’s newsletter (theconversation.com)
Authors: Thomas H. Goebel, Assistant Professor, University of Memphis